This is a method for making living water — water that is so good, two intuitive healers I trust called it "holy water." They confirm my own perception that this water literally vibrates with Life Energy and Light.
My goal was to make a superior drinking water from plain tapwater — to eliminate the chore and expense of carrying jugs around, dealing with empties, and paying (up to $1.25 per gallon) for distilled water plus added nano minerals.
The result draws upon everything I've learned about water, especially through the work of Masaru Emoto, Dr. Norman Shealy, the "Ocean TV" Russian scientists, and researchers in India who found cost-free ways to purify water.
Please go here to order do-it-yourself supplies. Or follow the links below for a description of the technology and complete instructions:
|
theLIGHThows
Energy-Enhanced Living Water
Individual Supplies and Kits
 Concerning our Prills, please note: Dr. Shealy, inventor of the Prills, has announced his reservations about the consistency of some of the products that mimic his technology, including those under the "Twilight" label. We carry only Shealy-approved Prills.
Concerning the Emoto labels, please note: The printing on the labels is waterproofed; however, we cannot guarantee their durability if they are subjected to repeated saturation. The labels themselves will remain affixed to glass until removed. |
|
Do-It-Yourself Energy-Enhanced Living Water
Individual Supplies
Kit (makes 2½ gallons per day)
|
About theLIGHThows Energy-Enhanced Living Water System
This system makes use of several technologies to create the highest-quality drinking water we have ever experienced.
- Filtration is the first technology we use. An ordinary countertop carbon filter will remove all chlorine taste, and any negligible chlorine that may remain is rendered harmless by the Russian WaterCard (see item 5, below). If you can afford it, you may wish to use a higher quality filtration system, such as Nikken PiMag or AquaPure, but it's not necessary. Those who have good well water may skip the filtration step.
- Shaking or whirling in a blender is the second technology we are using, to restore the aliveness that's lost when water is forced through pipes and delivered through a faucet. This shaking or blending technique, which provides oxygenation and sacred-vortex energy, has been tested in India, where contaminated water is made potable by first shaking it and then exposing it to four hours of sunlight. Even if it's well water, if it comes out of a tap it needs to be shaken or blended.
- The Emoto Effect is our third, extremely important technology, based upon Masaru Emoto's Messages in Water and his other books and lectures. Dr. Emoto shows us how the structure of water can be totally transformed to reflect whatever vibration you choose, simply through the use of words that relate to your intent. Also note that Dr. Emoto says water tumbling in a stream has a crystalline form — more evidence that tapwater needs to be shaken! (For more about the Emoto Effect, see our article at: Conscious Water Crystals: The Power of Prayer Made Visible.)
- Prills is our fourth technology. They were discovered by Dr. Norman Shealy, who found that a certain type of crystal, in the form of pearls or beads, when placed in water, would cause the water to become what he calls "thin" — meaning that it becomes a perfect life catalyst, entering into and rehydrating our cells. Prills are VERY reasonably priced, yet they apparently last for a lifetime. And the water they make seems to have almost magical, life-enhancing properties. Also, because it has a tight structure of small water crystals, Prill water will hold the Emoto Effect (which dissipates quickly in plain tapwater).
- A Russian WaterCard (4x4-inch BioGenesis Card) is incorporated as the final step in our system, to energize the water we have created and remove harmful effects of any possible residual chemicals. It is placed under your water storage container or dispenser. This card adds the holographic waveform structure of 200 different crystals.
Equipment to Make Energy-Enhanced Living Water
You will need:
- 1 two-gallon clear glass jar
- 1 one-gallon plastic water jug (like the ones that commercial springwater or distilled water comes in) or a blender and blender jar
- 1 sheet of clear label stock (available at a stationer's or Wal-Mart)
- 4 ounces of Prill beads
- 1 water filter (countertop, reverse osmosis, filter pitcher? it's your choice); not required if you have good well water
- 1 water dispenser or storage container, preferably ceramic or porcelain — it should hold 2 or 2½ gallons
- 1 Russian WaterCard (4x4-inch BioGenesis Card)
Our watermaking kits include the Prills, pre-printed Emoto Effect labels, and the WaterCard. We ask that you acquire your own filtration system, because there's such a wide range available and many people already have one, or have well water, in which case the filtration is not necessary. Of the more expensive filters, the Nikken Pi-Mag is best. Least expensive and perfectly adequate, although more work intensive, would be a simple filter pitcher (Brita, Culligan, Pur, etc.).
If you can't find a 2-gallon clear glass jar, see our list of links to Supply Sources available online.
Our system makes 2½ gallons of drinking water per day.
One-Time Preparation
Before you begin to make the water, you need to prepare your equipment, as follows:
- Put 3 quarts of water into your two-gallon glass jar, then remove exactly one cup. The jar is now one-third full. Make a mark on the jar where the water comes, so you will always be able to gauge this level.
- Wash the two-gallon glass jar and your chosen water dispenser or storage container in warm, soapy water, and rinse thoroughly with pure or filtered water (be careful not to obliterate your level mark — you might want to cover it with clear tape).
- Put the Prills (4 ounces for 2 gallons) into a saucepan full of boiling water and simmer them at the boil for 5 minutes. This makes sure they are sterile. Drain the sterilized Prills and put them in the two-gallon glass jar. Note that the Prill water MUST be made in a glass jar. Plastic will not work, although the water can be stored in plastic containers after it's made.
- Decide what word or words you want to use to transform the quality of your water. I use the phrase "Christ Consciousness." Dr. Emoto suggests the combination of Love and Gratitude as the highest possible vibration. Joy and Aliveness, Peace and Harmony, and Trust and Wisdom are other possibile phrases. Unless you have purchased our Emoto Effect label sheets, or know how to do this with your computer, just use a black magic marker and print the chosen word or words BACKWARDS (i.e. mirror image) on the clear labels. By printing it backwards, the word or phrase is turned inward toward the water itself, which Emoto says is preferable, rather than being turned outward toward the viewer. Affix this label to the side of the Prill jar. Again, you might want to cover it with clear tape. TheLIGHThows Emoto Effect labels have been waterproofed, but even so, we do not expect a single label to last forever unless we are very careful when pouring the water. Note that the glass jar must be clear in order to achieve the desired Emoto Effect.
- Place the BioGenesis Card in a heavy plastic Ziplok bag and close it very firmly. This goes underneath your water dispenser or storage container, with the grid side up.
Daily Water System
- Pour filtered water or well water into the plastic gallon jug or blender container, leaving plenty of air space at the top, and attach the lid. Shake this water for one minute or whirl in the blender for five seconds, then pour it into the 2-gallon Prill jar that has your Emoto Effect label. Continue until the Prill jar is full.
- First time only: Let this water sit for 24 hours.
- Pour the water from the Prill jar into your dispenser or storage container — but ONLY UNTIL you have reached the level mark you made. In other words, you must leave 11 cups in the Prill jar. Place your storage container or dispenser on top of the WaterCard (the card should be in its Ziplok bag, with the grid side turned up, toward the container).
- Refill the Prill jar as before, and let it sit for 10-12 hours (overnight or all day). In other words, you can refill the Prill jar twice a day, which will make more than 2½ gallons of Energy-Enhanced Living Water per day.
- Continue steps 3 and 4 to make your water supply each day. Always remember to shake the new water before adding it to the Prill jar, and always leave enough water in the Prill jar to start your new supply. If the water falls below your level mark, you will need to let the next batch sit for 24 hours again.
Supply Sources
Prill Glass Jars If you can't find one of these, large size Ball glass canning jars are available on the Internet at Goodman's. They cost $18 for the 2-gallon size, plus shipping.
Water Dispensers You can usually find these at local stores. And there is a very reasonably-priced selection of porcelain and ceramic dispensers, in a wide variety of patterns from flowers to beach scenes, at For Your Water. There's even a dispenser with angels on it! Dr. Emoto would approve.
Filters Inexpensive countertop filters are available on eBay. They attach to the faucet on your kitchen sink. Mine is an Equinox, and with the shipping it was less than $50. You can also get a good price for the higher quality filters on eBay, and other filtration supplies, including filter pitchers, also are available there and at places like Walgreen's, Wal-Mart, or any hardware store.
Ongoing Costs
Once you have created the configuration for your basic system, except for filter replacement as necessary, this water is absolutely free!
|
